PARALLEL AlAl GROOVE CLAMP H-FORM


Kat. br. serije 372020
Tip: MAl
Materijal: EN AW 6060
Standard: DIN 48 072

PARALLEL AlAl GROOVE CLAMP H-FORM

They are used to joint two parallel noninsulated aluminum conductors of the same or different cross sections. The conductors can be made of aluminum alloy (AAAC), aluminum conductors steel reinforced (ACSR) or ends of ABC from which the insulation has been removed. Their technical characteristics enable easy formation of joints in accordance with Standard SRPS N.F4106. They are made using die casting process and the inside grooves are cogged, which increases safety regarding pulling out and provides high-quality electrical contact (the grooves are made in such a way that aluminum oxide from the conductor surface is broken, which reduces transitional resistance between the clamp and the conductor). The body of the clamp is made of aluminum alloy of high tensile strength and is corrosion resistant. Its technical characteristics provide fast, easy and reliable installation and there are no parts that can fall off.
NOTE: On Customer's request the clamps can be delivered with hot-dip galvanized or stainless steel X 5 CrNi 18-10 bolt parts.

PARALLEL AlAl GROOVE CLAMP H-FORM

UNIMAX AlAl STEZALJKA

Note: This product is made on a special user request.


Jubilee

Contact

MAREL D.O.O.
VELIKO GOLOVODE b.b.
37000 KRUŠEVAC, SERBIA
Phone: +381 (0)37 35-66 262,
(0)37 35-66 266

e-mail:
marel@marel.rs